I have a question, namely, whether it is normal that the 1600x 3.6ghz used so much in Fortnite.
The processor is always around 40 degrees and uses 50% - 60%.
I came to it because I had looked at a few benchmarks with the same processor and all have never come well over 30% cpu usage.
My GraKa has less usage than the ingame processor because I play at relatively low settings.
I also sometimes had random lagg spikes, it could have something to do with it.
Would appreciate answers
For benchmarks, the load should be 100% if synthetic full load has been tested. In Fortnite, that's a good 40 ° C. More than cooling, even your GPU is bored. What's your idea for a beast?
If you lift the FPS limit, it gets more to do, but you do not need it.
I have a question, namely, whether it is normal that the 1600x 3.6ghz used so much in Fortnite.
What do you expect from a game that was badly badly programmed?
Bugs without end and the developers are coming to grips with fixing the problems. The one who started the game belongs to the wall. Normally, you would have to remove the game from the market, run bug fixing for 1-2 years and then offer it as a preliminary beta for testing. Otherwise you will not get the problems off the table.
The only way to remove Fornite on the PC and in 1-2 years try again to play. But until then, other and better (especially less flawed) games will appear on the market.
Thank you for your answer, but it was ok, not the GraKa but the Cpu.
For every video where the 1600x is tested in Fortnite the usage is only 30% and never goes higher than 40%, if they are running around normally.
That was the problem what I was about
But thanks anyway
But why is it with any, really any video, if you are after "Fortnite Amd 1600x" or "Fortnite Amd 1600" the usage of the Cpu of the people just over 50% and almost never at the 40% mark off.
I know how bad the game is programmed because I know it from the start and follow it
The utilization of course depends on the settings made.
Micro bearings could also depend on RAM or VRAM. If necessary, overclock the memory controller and RAM.
What settings in the game or where?
In the game I have everything on low and off except the visibility is far
Yes, the visibility raises the drawcalls erhbelich and can call for more CPU. Do you also bench with more FPS? What's going on in the background?
How much RAM do you have with which Specs?
GTX 1070 ti
16 gb 3200mhz TridentZ (which still runs on 3066 or so I have to change again in the bios)
Amd Ryzen 5 1600x (Cpu CoolerBrocken alpenföhn)
msi x370 per carbon
600W beQuiet power supply
The problem is that most of them test the games with everything on Epic and I just play on "esport" setting that means everything on low and off and sickness one under epic.
In the background I have only eig Firefox and discord
Then I would try the CPU overclock to 3.8 GHz and see how it works. The GPU should be bored, but are the drivers up to date? Do you have the power mode active in Windows?
All drivers are up to date and performance mode I have my opinion not activated I inform myself about it.
Are you also sure that the 144hz play because at higher Hz number, the load can be significantly higher at higher resolution, it is less cpu load at 1080p, you can prevent the cpuauslastjng when you play on 60hz
I'll take a look for the tip
Just try it.
The games are all on FPS Unlimited
Hmm same graphic card?
Most of them have 1060 6gb in the tests, but that does not have anything to do with the processor's downtime?
But the stronger the map, the more fps it has and if more fps then the cpu utilization is a lot higher while the graka gets bored because the cpu is allowed to break most of it and a 1070ti is a good bit better than the 1060 6gb
Maybe jz sounds a bit stupid, but i just looked at a cpu1 all the time xd and not all the CPU usage jz is also in the room of 30%
Have still ne question is the normal that can be so different (the threads)
Yes, that's normal! Since unfortunately very few games are optimized for many cores, usually a core is used up to 100% and unfortunately not all would be so you would have far more fps but that will take even longer! I own a 1600 to 3.8ghz and it is usually only 1 core used to 100% all others are as busy as yours
Thank you you helped me a lot brotha
May I ask ma how you have cooled the PC? So ne cooled card I would like to xD
Have 3 extra fan in there and somehow set ka have no plan
So in the back I have a fan that pulls the air outwards, if you go further to the right
, then comes the Cpu with the Brock Alpenföhn
And then further to the right, there are 3 fans on the front which blow air to the left.
And the GraKa is overclocked and fan is set to 55%
A oke. Sounds pretty neat when I hear the alpenföhn
I got grad so pure, because he is so fat.
I also can only occupy 2 ram places, because he completely obscures one and the next to it just so bores.
Joa you also have enough background processes are running a bit of a load.
