Need help with my pc mainboard but is fan and everything else is out of picture?

kr
20

I need help i bought my pc on ebay classified ad used it for 5 days and it broke so i played fortnite 2 times and the pc is supported 2 times (each time individually) and then i turned on in the evening not when i went to the turn on button press the button appears blue for 0.1 seconds and goes away again but the fans don't work anymore I've tested many can someone help me please would be very very grateful

Ha

Since the fans do not work, it overheats immediately and therefore turns off (so that it does not start to burn). So I think it's the fan

Check carefully whether the fan is connected or something (make sure that the PC is completely switched off and it is not hot! (Also switch it off from the power))

kr

So graphics card is not only mainboard is a yellow light (I also tried to take power and plug it back in but it still doesn't work)

Ha

Apparently something is wrong with the mainboard. Because the motherboard controls everything. Are you sure that the mainboard fits the PC?

kr

Well I don't know about pc so well but the pc went 2 to 3 days and then it happened

Ag

Would try another power supply, my guess that the power supply does not work.
If you played, when (after what time) did it crash? Don't think it's a heat problem.

Which board is it? (name due to yellow light)

Ha

Since he could still cope with it but it may be that the mainboard was not correctly accepted by the PC and possibly got a short circuit

kr

Played for about 50 minutes or so then it's supported it's asus p8z77-m

kr

I want to send you a picture of PC but how do I send it here you have discord

Ag

Did you transport the compi?
Open it and press all the elements (memory, graphics card, power connections, etc.). Could be that a loose element causes a short circuit, which can also be caused by heat (expansion).

kr

I took par pictures of pc removed and reinstalled it was anyway so everything checked more than 10 times but somehow it just does not want to start

Ag

Which LED is on or lit? Is it the one to the right of the RAM banks?
Here you will find the operating instructions for your board:
https://www.asus.com/...sk_Manual/
Foam on which LED lights up.

Ag

Did the previous owner overclock the CPU, do you know?
The manual says what needs to be done. (P. 1-20)

kr

The ON Standby Power lights up yellow I don't know about that

Ag

This is stated in the operating instructions:
1-19 Chapter 1: Product introduction 1. Standby Power LED (SB_PWR) The motherboard is equipped with a Standby Power LED which lights up when the system is in switched on, sleep or soft-off mode. This is a reminder that you should shut down your system and remove the power cord before adding or removing motherboard components. The following illustration shows the location of the LED on the motherboard.

Now a stupid question, if the LED lights up, did you press a key on the keyboard to get out of standby?

Did you have a blue screen when it crashed, or did it just switch off?

kr

Before that happened 3 or 4 days ago, I had a blue screen once while I was in game, but then I restarted the PC and everything was fine and then the PC doesn't start anymore because of the standby

Ag

So I would do the following:
Remove the BIOS battery for 30 seconds, then put it back in and try to start.

If that doesn't work, then use the exclusion process - that is,
Disconnect everything, except for the power supply and keyboard, also graphics card out and only one RAM bar in, connect the monitor to the board.
Should it then start, then gradually install all components SINGLE.
What I read, you have to pay attention to the correct configuration of the memory, it is also in the manual. (Please note).
If a part is defective, you can determine this by excluding it.

Have you spoken to the seller once?

Ag

Any key, no matter which.

kr

I'll give it a try thanks to you

kr

So that with the sleep mode did not work but I will now disconnect everything and build again individually

kr

Did but still doesn't work the same even though I only use mainboard memory and power supply