Pc little much too little power than actually has to be?

Ma
- in Hardware
52

Thank you for reading this question

And it's about my PC that I assembled a few months ago

Components

RTX 2060s Ryzen 5 2600x MSI B450-A Pro Max

In games like Fortnite, I have FPS drops to the end. For example, when I look at a city I have from 200 fps to 100 or for the smallest things they drop. When I'm in the lobby, my colleagues with a GTX 1060 have 480 FPS and I only have 320 in the lobby on the lowest settings. I was told that this could be due to my mainboard if it is due to the mainboard then I would buy a new one.

I would be very happy to receive answers

Da

Maybe your colleagues are playing on a different resolution.

Ma

No all the same

Pa

The settings must be 1: 1 the same. The RAM can also make a difference (XMP activated?), The mainboard less so.

Ma

No xmp is not on

have the cpu on 4ghz oc

thank you for your reponse

Can it really not be on the mainboard because the gpu has already been replaced 3 times, first it was an amd rx590 dan gtx 1660ti and now rtx 2060s

Da

You are sure? The settings change automatically when the monitor has a slightly higher resolution.

Sh

Should also be a little smarter. Download msi afterburner and msi kombustor down and run par benchmarks. IMPORTANT: DON'T OVERACK YOUR GRAKA WITH MSI AFTERBURNER WITHOUT PRIOR KNOWLEDGE! When you look at the benchmarks, look how she does the graphics card. Zmb how the heat works, etc. Should it be due to the heat, then set your fan cooling high at msi afterburner and then press hack, watch overclocking tutorials and try to clock the graphics up a bit, don't overdo it otherwise you can bye graphics say.

Ma

Yes already everything has normal in 1920 1080 but can it not be on the mainboard?

Da

No, not really.

Ma

Have only the voltage of the GPU increases in the msi afterburner

Sh

Is ok the main thing is not going straight to the maximum. Btw try to set the temperature limit and power limit very high.

Ma

I have now tested temperatures were not over 68 degrees always had so 59 fps

Pa

XMP should be on but don't think you only have 2133MHz DDR4. With XMP you can usually get something out of it.

Under normal circumstances, the mainboard has little influence.

Ma

Had turned it on and then my pc crashed

Sh

What about the other things?

Ma

Is already high now I do the test in full hd and have 45 fps

Ma

Which

Sh

Things like zmb M.S or GPU Load

Ma

Was 98 percent loaded during the test and ms were so 17

Je

Is there an obvious bottleneck somewhere? GPU, CPU, RAM usage, temperature? (Task Manager, GPU-Z, CPU-Z etc. Come in handy to find out)
FPS drops are basically nothing unusual. If you pan from a relatively empty place in the world to a city at once, all of this has to be loaded onto the GPU first. If you look away, it's not in the GPU memory at the moment. A frame drop can of course also have other reasons, e.g. Geometry / shader complexity etc. That depends on the scene.

"Only" 320 FPS is whining on a high level. Chances are that your driver simply capped the frame rate because anything above 120 FPS is a waste of energy. Without Fraps you wouldn't even notice the occasional drops from 200 to 100 FPS.

Sh

If everything looks good, assume that it is not because of the graphics card.

Sh

How much ram do you have?

and is it on dual channle?

Ma

Yes that is only in the lobby there you always have more fps first huge thanks for the super nice answer but when i play on high settings and my colleagues then i have more fps than they and when we play on low where it is about high FPS can then have the more and more stable although the worse components have

Ma

Yes have 2 8gb ram sticks

Sh

Do you have it in the right ram slots? Or not directly next to each other if you have more than 2 slots

Ma

I have cpu-z how can i find out with the bottleneck

Ma

Yes my uncle did there's always 1 space between free

Sh

Xmp mode on?

Ma

No, I turned it on then I had a crash but can try again

Sh

Try it again, should it crash again then let me know it boosts your system a lot.

Ma

Okay i do thank you

Si

Most likely the CPU bottlenecks, I would say, I have the 7 2700X and the CPU pretty much bottlenecks.

Ma

How do you mean that can you please describe it again for stupid xdxd

Ma

So now the A-XMP profile 2 is selected dan on 3200mhz has started not everything runs

Sh

How do you mean it's not all going

Ma

Said everything is still running srry

Ma

One said it is a bottleneck can that be the cpu on 43ghz oc

Sh

Then fine, do the benchmark again and then give me the values again.

Je

Comparing such high FPS is usually not useful. What counts is the FPS under load. And they are higher with you.
Don't worry about stability either. As long as it doesn't "hack", it doesn't matter. The stability can also depend on the graphics settings.

So the "bottleneck" is the component that limits the frame rate. I would start with the Task Manager and then in the "Performance" tab. If anything is 95-100%, you've probably found your bottleneck. If not, it is possible that your hardware is throttled (performance "artificially" limited), either because the temperature is too high (you can e.g. Watch with CoreTemp) or for other reasons (for laptops e.g. Battery operation, Windows energy saving settings, …). It can also e.g. Caused by the driver (FPS Cap), you can trust the driver, he just wants to prevent unnecessary waste of energy and heat development.

The whole thing is actually only worthwhile if you have FPS below 60 (possibly 120 if your screen can do that). Otherwise, more FPS are useless because the screen is capped anyway and you can't see any difference.

(I would also advise against overclocking in principle, because you can fry your hardware if you don't know your way around)

Sh

The graphics card is probably slowing down your CPU.

Ma

Do you mean that the gpu decelerates my cpu or the cpu decelerates my gpu

Sh

Cpu slows down your gpu. I wouldn't think so, but it could be.

Ma

Thanks again my components are very well rated but when playing fortnite with low settings it sometimes hacks in the endgame dan i feel it extremely

Ma

Temp is max 68 have 45 fps 22ms load is 97 percent with full hd in the test

Sh

You probably have a bootleneck. Would you upgrade your cpu or downgrade your gpu.

Ma

Okay but can it be due to the mainboard?

Had a GPU stress test done because it is normal that they are busy

okay, what can you recommend as an ubgrade?

or if I downgrade the gpu then I have more fps or like jz so on low settings

Sh

So 1. No it is not the mainboard but the cpu! 2. As an upgrade, I would probably recommend the ryzen 7th series. Or 9 but that could be a bit expensive. Would you recommend downgrading the GPU or perhaps to take a slightly cheaper variant. You can just sell the gpu and then easy to get the money to get a zmb rx 5700 xt is similar to the rtx 2060. But bottleneck should most likely not exist. 2. You will sooner get more fps and it will also be possible to play on epic don't worry xD

Ma

Okay, you could also buy the ryzen 5 3600x
and how do you downgrade the gpu
but thanks for the answer

Sh

Quite simply, when you have the new gpu then first uninstall all drivers, then take out all power cables etc., take out the gpu, install the new ones, download new drivers from the manufacturer's website and you have it.

Sh

You can buy them of course, but I'm not sure if that will work.

Ma

Thanks

Sh

With pleasure

Si

Your CPU slows down your GPU, I have the 7 2700X and it slows down my graphics card too. The 2060 Super is actually a good graphics card, so it should be your processor